ADEMCO VISTA 10 Guia de preparacion descargar pdf (Pagina 23)

Section 3 – Programming Overview

3-3

Mechanics of Programming

To program the system from a keypad:

• You must use a 2-line Alpha display keypad.

• The panel must be disarmed.

Data Field Programming Procedures

Task Procedure

Enter Program Mode

A) Press both [

✱

] and [#] at the same time within 50 seconds after power is applied to

the control,

B) After power-up, enter [Installer code (4-1-1-1)] + 8 + 0.

(method “B” is disabled if you exit the program mode using

✱

98)

Go to a Data Field

Press [

✱

] + [Field Number] (for example,

✱

21).

A display of “EE” or “Entry Error” means you have entered a nonexistent field.

Simply reenter [

✱

] plus a valid field number.

Enter Data

When the desired field number appears, simply enter the digits required. The keypad

beeps three times after the last digit is entered and automatically displays the next

data field in sequence.

If entering less than the maximum digits available (e.g., phone number field), enter

the desired digits, then press [

✱

] and the next data field number to be programmed,

to end the entry.

Review a Data Field

Press [#] + [Field Number].

That field’s data is displayed, but no changes can be made.

Delete an Entry in a Field

Press [

✱

] + [Field No.] + [

✱

] (applies only to primary/secondary phone number,

subscriber account number, and download telephone number fields).

Interactive Mode Programming (

∗

56,

∗

58,

∗

80,

∗

81, and

∗

82)

Enter Interactive Mode

Press

[

✱

] +

[Interactive Mode No.] (for example,

✱

56) while in Program Mode. The

Alphanumeric display keypad will display the first of a series of prompts requesting

entries.

After making the appropriate entry, press the

[

✱

]

key to accept the entry and

continue to the next prompt.

Loading Factory Defaults/Initializing for Download

To Load Default Entries

Press

✱

97 while in Program Mode. This resets all data fields to the factory default

values (if any). Use

✱

only if you wish to return to the original factory-programmed

defaults.

To Initialize Download ID

Press

✱

96 while in Program Mode. This initializes the system for downloading and

resets all the subscriber account numbers and CSID.

Do not press

✱

97 to load defaults if any programming has been done previously—data already programmed into

the system will be changed!

Exiting the Programming Mode

Prevent Installer code reentry

Press

✱

98. Exits Programming Mode and prevents reentry by:

Installer Code + [8] + [0]. To enter the programming mode if

✱

98 was used to exit,

you must first power the system down. Then power up again, and press

[

✱

]

and [#] at

the same time, within 50 seconds of powering up.

Allow Installer code reentry

Press

✱

99. Exits Programming Mode and allows reentry by:

Installer Code + [ 8] + [0] or by: Pressing

[

✱

]

and [#] at the same time, within 50

seconds of powerup.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 79 80

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA 10 Guia de preparacion Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA 10