ADEMCO VISTA-20HWse Guía para resolver problemas descargar pdf (Pagina 10)

–10–

Section 2. INSTALLING THE CONTROL

This section provides instructions for mounting the control cabinet, and installing

the cabinet lock (if used). Also included in this section are instructions for the

following:

• Installing the main PC board

• Standard phone line connections

• Installing the back-up battery in the cabinet

• Connecting the AC transformer

• Making earth ground connections

Mounting the Cabinet

Mount the control cabinet to a sturdy wall using fasteners or anchors (not

supplied), in a clean, dry area which is not readily accessible to the general

public. Four mounting holes are provided at the back of the cabinet.

Installing the Lock (if used)

Use an Ademco No. N6277 Cam Lock and No. N6277–1 Push-On Clip (Retainer

Clip).

Note: The cabinet can be closed and secured without a lock by using 2 screws

in the cover's edge.

CABINET DOOR BOTTOM

RETAINER

CLIP

RETAINER CLIP

(NOTE POSITION)

RETAINER

SLOTS

LOCKED

UNLOCKED

Figure 1. Installing The Cabinet Lock

1. Remove the cabinet door. It is

easily removable for servicing

and is easily re-installed

2. Remove the lock knockout from

the control cabinet door. Insert

the key into the lock. Position the

lock in the hole making certain

that the latch will make contact

with the latch bracket when the

door is closed.

3. Hold the lock steady, and insert

the retainer clip into the retainer

slots. Position the clip as

illustrated in order to permit easy

removal.

Before installing the cabinet's contents, remove the metal cabinet knock-

outs required for wiring entry. Do not attempt to remove the knockouts

after the circuit board has been installed.

Mounting The Control's Circuit Board in The Cabinet (Fig. 2)

1. Hang two short Black

mounting clips (provided) on the raised cabinet tabs

(see Detail B in Fig. 2).

2. Insert the top of the circuit board into the slots at the top of the cabinet. Make

sure that the board rests on the correct row (see Detail A ).

3. Swing the base of the board into the mounting clips and secure the board to

the cabinet with the accompanying screws (see Detail B in Fig. 2).

Figure 2. Mounting The PC Board

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 83 84

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA-20HWse Guía para resolver problemas Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA-20HWse