ADEMCO 4120XM Especificaciones descargar pdf (Pagina 40)

IF INSTALLED

General

In Case Of Fire

Alarm

Consult with your

installer, then place a

check in box opposite

key pairs (or single

key) that have been

assigned for FIRE, if

programmed in your

security system.

Your fire alarm system (if installed) is on 24 hours a day, for continuous

protection. In the event of an emergency,

smoke and heat detectors signal

your system, triggering a loud, interrupted alarm sound from the Console. A

loud, similar interrupted sound is also produced by optional exterior sounders.

A FIRE message

will appear at your Console and remain displayed until you

silence the alarm.

Should you become aware of a fire emergency before your detectors sense

the problem, do the following:

1. At the nearest Console, manually initiate an alarm by pressing the panic

key pair

(or single key A, B or C) that has been assigned for FIRE

emergency (if programmed by the installer) and hold down for at least 2

seconds.

❑ m ‘ K1 CONSOLESW,-rI-l

❑ ~ CONSOLES WITH

❑ ~]& ~] pANIC KEY pA,Rs

❑ ~ SINGLE F’ANIC KEYS

•1 p---J&J---J

❑

IEI

2. Evacuate all occupants from the premises.

3. If flames and/or smoke are present, leave the premises and notify your

local Fire Department immediately.

4. If no flames or smoke are apparent, investigate the cause of the alarm.

The zone number(s) of the zone(s) in an alarm condition will be displayed

at the Console.

–40-

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Sin comentarios

ADEMCO 4120XM Especificaciones Pagina 40