
DISARMING THE SYSTEM AND SILENCING ALARMS
Using the
[~ OFF Key
/MPORTAiVT:
If you
return and the burglary
alarm is sounding, DO
NOT
ENTER THE PREMISES, but
call the police from a nearby
safe location.
If you return after an alarm
has occurred and the main
sounder has shut itself off,
the console will emit rapid
tones upon
entering,
indicating that an alarm has
occurred
during your
absence (this is the Memory
of Alarm feature). LEAVE AT
ONCE and CONTACT THE
POLICE from a nearby safe
location. When safe to do so,
re-enter and follow the
procedure for silencing an
alarm in progress.
The OFF key is used to disarm the system and to silence alarm and
trouble sounds.
To Disarm the System
Enter your
security code and press the OFF key. The “Ready”
message will be displayed, and the console will emit a single tone to
confirm that the system is disarmed.
To Silence a Burglary Alarm in Progress*
Enter your security code and press the OFF key to silence the alarm
(or warning tones of a Memory of Alarm).
Note the zone in alarm on the console display, and make that zone
intact (close protected door, window, etc.). Now enter another OFF
sequence to clear the display. If the display will not clear and does not
provide a “Ready” message after the displayed zone has been made
intact, notify the alarm agency.
* See page 41 for additional information relevant to silencing
fire alarms.
See important note at left regarding alarms that occur when returning
from outside, including the Memory of Alarm feature.
Refer to the
SUMMARY OF AUDIBLE SOUNDS AND DISPLAYS section for
information which will help you to distinguish between FIRE and
BURGLARY alarm sounds.
-26-
Comentarios a estos manuales