ADEMCO 4120XM Especificaciones Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
TESTING THE SYSTEM
TO BE CONDUCTED WEEKLY
Testing Your
The Test key puts your system into the Test mode, which allows each
System
protection point to be checked for proper operation.
Note that no alarm
reports will be sent
to
the
central
monitoring station
while the system is in
the Test mode.
r
The Console will
sound
a single tone
at 75-second inter-
vals (if no protection
points are violated),
as a reminder that
the system is in the
Test mode.
1.
2.
3.
4.
5.
With the system in the disarmed mode, close all protected windows, doors,
etc. The “Ready to Arm” message should be displayed.
Enter your security code and press the TEST key.
The external sounder should sound for 3 seconds and then turn off.
If the sounder fails to sound, the system’s back-up battery maybe too weak
to activate the external sounder (Fixed-word consoles
will display BAT with
no ID number, Alpha consoles
will display SYSTEM LO BAT). This may
be due to a weak back-up battery caused by activation of the external siren
or bell for an extended period during a recent alarm.
Even if the sounder fails to sound, the system will still enter the Test mode,
allowing each protection point to be checked for proper operation, as
indicated in steps 5 through 10.
Note: If a message indicating a low system back-up battery was displayed, allow
at least 8 hours for the battery to re-charge, then enter
the Test mode again to
check that the sounder comes on for 3 seconds and then turns off. If it does not,
the sounder may be at fault and you should call for service.
Doors and Windows: Open and close each protected door and window in
turn. Each action should produce 3 tones. The identification of each faulted
protection point should also be displayed.
–34-
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Comentarios a estos manuales

Sin comentarios