ADEMCO VISTA-5OUL Guía de usuario descargar pdf (Pagina 15)

SECURITY CODES & AUTHORITY LEVELS

General Rules

●

on Authority

Levels and

●

Changes ●

●

A user may not delete or change the user code of the SAME or HIGHER authority than

which he is assigned.

A user may only ADD users to a LOWER authority level.

A user may assign access codes only to those partitions to which the user adding the

code has access. (ex. a user with access to only partition 1 cannot assign codes in

partition 2.)

The only way to assign a user’s authority level is by using the “Add A User”

procedure. To change a user’s authority level, that user must first be deleted, then

added again.

A user can only be DELETED or CHANGED from within the partition he is assigned.

User numbers must be entered as 2-digit entries. Single digit user numbers must be

preceded by a “O” (example, 03, 04, etc.). Security codes are entered as 4-digit

numbers.

Before assigning a security code, be sure it does not conflict with any DURESS code.

Note: When adding, changing or deleting users, all other alpha consoles in that partition

will display “User Edit Mode –

Please Stand By”, and key depressions (except Panic)

at those consoles will be ignored. Panic key depressions will cause an alarm and

terminate user entry.

To Exit User Edit You can exit any of the user edit modes described on the following pages at any time

Mr)de

by doing the following:

1. Press either ~ or

❑, or don’t press any key for 10 seconds.

-15-

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 65 66

Sin comentarios

ADEMCO VISTA-5OUL Guía de usuario Pagina 15