ADEMCO Vista AT Guía de usuario descargar pdf (Pagina 15)

– 15 –

Creating Schedules (cont’d)

3. Enter the desired 2-digit event number from the following list.

00 = remove the scheduled event

01 = turn a programmed device on or off

02 = set a user access schedule for one or more users)

ENTER EVENT

03 = send “child-not-home” report; see Child Not Home notes below

04 = automatically arm the system in STAY mode at a specified time (cannot be used if a common area

exists)

05 = automatically arm the system in AWAY mode at a specified time (cannot be used if a common area

exists)

06 = automatically disarm the system at a specified time

07 = Display the word “REMINDER” at a specified time

08 = Disarm Time Window (system can be disarmed only during this time period; Exception: if a burglary

alarm occurs, the system can be disarmed outside the scheduled time window)

Press [∗] to continue.

4. For event number “01,” enter the 2-digit output number (01-04, 17-18)

associated with this schedule. Otherwise, this prompt is skipped.

Press [∗] to continue to the “Start” prompt below.

DEVICE NUMBER

5. For event number “02,” enter the 1-digit access group number (1-8).

Otherwise, this prompt is skipped.

Press [∗] to continue to the “Start” prompt below.

GROUP NUMBER

6. For event numbers “03-08,” enter the partition number to be armed or

disarmed. Otherwise, this prompt is skipped.

0 = arm all; 1 = partition 1; 2 = partition 2; 3 = common partition

Press [∗] to continue to the “Start” prompt.

PARTITION

7. Enter the event’s start time and days of week: Hour = 00-23; minute = 00-

Days = Position the cursor under the desired days using the [∗] key to

move forward, then press “1” to select the day(s).

Press [∗] to continue.

START SMTWTFS

HH:MMAM 1000000

8. For events 04 or 05, enter the desired amount of time, 01-15 minutes, the

system should warn of impending arming. The system beeps once every 30

seconds to alert users that arming will soon occur. Otherwise, prompt is

skipped.

Press [∗] to continue.

WARNING DELAY TIME

9. Enter the event’s stop time and days of week. Refer to step 7 for available

entries.

Press [∗] to continue.

STOP SMTWTFS

HH:MMAM 1000000

10. Enter the desired repeat option.

0 = no repeat; 1 = repeat schedule weekly

2 = repeat schedule biweekly (every other week)

3 = repeat schedule every third week; 4 = repeat schedule every fourth

week

e.g., To make a schedule that happens everyday you would select all days

with a repeat count of 1.

NOTE: Schedules run sequentially from Sunday to Saturday and reset on

Sunday at midnight. If repeat count is 0, only those events scheduled from

the day the schedule is set to Sunday will occur. Events scheduled after

Sunday will be ignored.

REPEAT OPTION

0-4 X

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista AT Guía de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista AT