ADEMCO Vista-128B PLUS Manual de usuario descargar pdf (Pagina 4)

–5–

13. Exit Programming Mode.

Exit programming mode by pressing either *98 or *99. Additional entries of *99 is required if

the exit is being done from fields 1*00 and above.

To prevent re-access to programming mode using the Installer's code, use *98. The only way

to re-access programming mode is by depressing both the [*] and [#] keys at the same time

within 30 seconds of power up.

Exiting by using *99 always allows reentry into programming mode using the Installer's code.

Either way of exiting will allow access via downloading. Note that if local programming lockout

is set via downloading, programming mode cannot be entered at the keypad.

1 2 3 4 5 6 7 8 9 ... 38 39

Sin comentarios

ADEMCO Vista-128B PLUS Manual de usuario Pagina 4