ADEMCO Vista-128B PLUS Manual de usuario descargar pdf (Pagina 13)

– 14 –

Programming With #93 Menu Mode

NOTE: The following field should be preset before beginning: 2*00 Number of Partitions. In addition, receivers

should be programmed via Device programming.

After programming all system related programming fields in the usual way, press #93 while still in programming mode to

display the first choice of the menu driven programming functions. Press 0 (NO) or 1 (YES) in response to the displayed

menu selection. Pressing 0 will display the next choice in sequence. Menu selections are as follows:

ZONE PROG?

0=No 1=Yes

For programming the following:

• Zone Number

• Zone Response Type

• Partition Number for Zone

• Dialer report code for zone

• Input Device Type for zone (whether RF, polling loop, etc.)

• Enrolling serial numbers of 5800 series transmitters & serial polling loop devices into the

system.

SEQUENTIAL LEARN?

0=No 1=Yes

For programming the following:

• Input Device Type for zone (whether RF, polling loop, etc.)

• Enrolling serial numbers of 5800 series transmitters & serial polling loop devices into the

system (all other zone characteristics must be pre-programmed).

REPORT CODE PROG?

0=No 1=Yes

For programming the following:

• Alarm report codes for zones

• Restore & supervisory codes

• All other system report codes

ALPHA PROG?

0=No 1=Yes

For entering alpha descriptors for the following:

• Zone Descriptors

• Installer's Message

• Custom Words

• Partition Descriptors

• Relay Descriptors

DEVICE PROG?

0=No 1=Yes

For defining the following device characteristics for addressable devices, including keypads,

RF receivers (5881), output relay modules (4204/4204CF), 4285/4286 VIP Module, ECP

long range radio (7820), and vista gateway module:

• Device Address

• Device Type

• Keypad Options (incl. partition assignment)

• RF House ID

• LRR Options (incl. programming radio)

RELAY PROG?

0=No 1=Yes

For defining output relay functions.

RLY VOICE DESCR?

0=No 1=Yes

For entering voice descriptors for relays to be used with the 4285/4286 VIP Module.

CUSTOM INDEX ?

0=No 1=Yes

For creating custom word substitutes for VIP Module annunciation.

CLEAR RF SERIAL#?

1=Yes 0=No

For deleting all RF serial numbers presently in the system, if an undesired transmitter has

been enrolled during sequential enrolling.

#93 MENU MODE KEY COMMANDS

The following is a list of commands used while in the menu mode.

#93 Enters Menu mode

[✱] Serves as ENTER key. Press to have keypad accept entry.

[#] Backs up to previous screen.

0 Press to answer NO

1 Press to answer YES

001-009 All data entries are either 2-digit or 3-digit entries.

000 Exits menu mode, back into field programming mode, when entered at the first question for each category.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-128B PLUS Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-128B PLUS