ADEMCO VISTA-20SE Guía de usuario descargar pdf (Pagina 8)

Vista 20SEa Training Guide Page 8

3. Vista 20SEa Instruction Addendum

Duress

User code # 16 is a global Duress code. Entry of this code will generate a Contact ID

event code of 121 with a User # of 92. If used in conjunction with an Open or Close event,

it will also send an Open/Close by User #16.

Supervised Bell/Siren Output

By cutting the Red jumper above terminals 1 and 2, the alarm output can be supervised by

fitting a 2K-ohm resistor at the noisemaker. A short or open of the resistor will result in a

Check/Trouble display and Contact ID Event Code of E321.

Strobe Output

Connect negative of Strobe to pin 8 of the nine wa y connector located near the middle of

the circuit board.

Connect positive of Strobe to terminal 5 of the main terminal block.

No programming is required for the Strobe function.

Confirmation of Arming Ding Options

An additional option for sounding the noisemaker when the system has been armed with

an RF button is now available for either or both partitions. Program field *38 will now

accept an entry of 2 for this feature.

4 Wire Smoke Detectors

Smoke Detectors should be powered from the Programmable Trigger Output, pin 9 (-) and

pin 7 (+), with Program field *90 set to 2, Resettable Smoke Detector Power.

RF Jamming Supervision

The 5882 RF receiver supports RF Jam Detection. If field * 22 is set to 4, a continuous RF

transmission of greater than 30 seconds will generate a console display of RF Jam and a

Contact ID event code of 344 to be sent to the Central Station.

+ -

9 Way Pin Header

Below Heatsink

+ -

Strob

1 2 3

Vista 20SEa Main

Smoke Detector

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Sin comentarios

ADEMCO VISTA-20SE Guía de usuario Pagina 8