ADEMCO VISTA-20SE Guía de usuario descargar pdf (Pagina 21)

Vista 20SEa Training Guide Page 21

6128RF Local Mode Programming

Training Module

Key Points:

• Use local mode when adding wireless Keypads or wireless keys to an Ademco control

that does not support wireless.

• Wireless keys enrolled into the 6128RF console are called ‘local keys’

• Local keys are enrolled directly into the 6128RF

• The unique serial No. of each key is learnt into the 6128RF

− Thus maintaining the added security that unique encoding offers

• Local keys do not occupy zones of the control.

• Up to 8 wireless Local keys may be programmed into the 6128RF

• Local mode passes signals from wireless keypads and keys to the control as console

data (as though keys were pressed on a hardwired console)

• Local keys are not supervised for low battery conditions.

• Local keys are assigned as a user code and limited to number of user codes available

on the panel(10A – 7 user codes, 20SEA – 8 user codes)

Install the Unit:

• Connect the 6128RF across the Console Bus as you would a standard 6128 or 6139

console

• Program User codes into the system

− This is important as the 6128RF transmits valid user codes to the panel when a

5804 is used.

− If the user code is invalid the 5804 will not operate.

To Add Local 5804 Keys To 6128RF

Enter 6128RF Programming:

• Within 30 Secs of powering up the 6128RF, hold down the 1 & 3 keys to enter keypad

program mode

• “00” and “—“ will be flashing on the display

• Press “5” on console to enter Local key programming

• “d-“ will be flashing on the display

• Select the wireless key device No. to program (1 – 8)

• “d1, d2” etc will be displayed depending on the device selected

Local Key Programming (Option 5):

1. Serial No. Programming

2. 4 Digit User Code

4. Program Loop Number function

5. Relay Action

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Sin comentarios

ADEMCO VISTA-20SE Guía de usuario Pagina 21