ADEMCO VISTA 10 Guía de usuario descargar pdf (Pagina 32)

– 32 –

FIRE ALARM SYSTEM

If Installed

General

Your fire alarm system (if installed) is on 24 hours a day, for continuous

protection. In the event of an emergency, the strategically located smoke and

heat detectors will automatically send signals to your system, triggering a

loud, interrupted pulsed sound

from the keypad(s). Optional exterior

sounders will also produce this sound. A “FIRE” message will appear at your

keypad and remain on until you silence the alarm (see instructions below for

silencing fire alarms).

TYPICAL FIRE ALARM DISPLAY





ALARM

FIRE

FIXED-WORD ALPHA

Silencing Fire Alarms

1. You can silence the alarm at any time by pressing the OFF key (the

security code is not needed to silence fire alarms). To clear the display,

enter your code and press the OFF key again (to clear Memory of Alarm).

If the keypad's fire indication does not clear after the second OFF

sequence, smoke detectors may still be responding to smoke or heat-

producing objects in their vicinity. Investigate, and should this be the case,

eliminate the source of heat or smoke.

If this does not remedy the problem, there may still be smoke in the

detector. Clear it by fanning the detector for about 30 seconds.

When the problem has been corrected, clear the display by entering your

code and pressing the OFF key.

* Temporal pulse sounding is produced and repeated for fire alarms, as follows::

3 pulses–pause–3 pulses–pause–3 pulses–pause…., repeat.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

ADEMCO VISTA 10 Guía de usuario Pagina 32