ADEMCO VISTA 10 Guía de usuario descargar pdf (Pagina 11)

– 11 –

SECURITY CODES

General

At the time of installation, your installer programmed a personal 4-digit

Master code, known only to you. This code is used to perform most system

functions, including arming and disarming of the system. As an additional

safety feature, up to 4 temporary User codes can be assigned for use by

those not having a need to know the Master code. Note that the Master code

remains in effect even when other User codes are assigned.

IMPORTANT! When performing any of the procedures that follow, do

not allow more than 2 seconds to elapse between steps, otherwise the

entry will be aborted, and the procedure must be repeated from its

beginning.

To Assign, Change, or Delete User Codes

The Master security code can be used to assign up to 4 secondary User codes.

The Master code can also be used to change any User code or to remove

(delete) any secondary User code from the system. It is recommended that

obvious codes such as 1-1-1-1 or 1-2-3-4 not be assigned.

To Assign or Change a User Code:

1. Enter your Master code and press the CODE [8] key.

2. Enter the single-digit User Number for whom a code is to be assigned

or changed. Codes for User Nos. 3 to 6 may be assigned.

3. Enter the desired 4-digit code for use by that User number. The keypad

will beep once when a User code has been successfully entered.

To Delete a User Code:

Perform steps 1 and 2 above and then stop. In a few moments, the keypad

will beep once, indicating that the existing code has been deleted.

Temporary users should not be shown how to use any system function that

they do not need to know (e.g., how to bypass protection zones).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Sin comentarios

ADEMCO VISTA 10 Guía de usuario Pagina 11