ADEMCO Accord Especificaciones descargar pdf (Pagina 13)

Assembling the Control Panel Into the

Enclosure

1. Insert the four plastic PCB support pillars into the four holes in the enclosure

base, see Figure 2.2.

2. Place the main PCB on top of the pillars so that the tops of the pillars locate

into the PCB mounting holes.

3. Carefully apply pressure to the PCB in the area immediately surrounding each

of the PCB mounting holes using two thumbs so that the PCB rests firmly onto

the shoulders of the pillars.

Note: Excessive pressure on the PCB will cause irreparable damage.

SW1  Accord Tamper

Switch SW1 on the Accord control panel PCB is the control tamper. Removing the

enclosure lid releases the tamper switch; this causes a tamper alarm if the system is

not in Programming Mode.

RV1  Loudspeaker Volume

The variable resistor RV1, see Figure 2.1, alters the volume of the loudspeaker output

from the control panel.

Note: This affects the volume of the exit/entry tones from the output but not the

Alarm tones.

Zone Links

The eight zones, the zone tamper and the bell tamper circuits can be shorted using the

Zone Links provided in the spares pack. It is strongly recommended that this is done

if any the these circuits are not to be used.

SECTION 4: OPERATING

THE ACCORD

Setting and Unsetting the system

Before setting the system:

 Ensure all doors and windows are secure.

 Ensure that none of the movement detectors are obstructed.

Full Set [1]

To Full Set the system:

 Enter your User Code then press the 1 (Full Set) key.

 A constant exit tone is heard which changes to a broken tone as you pass the

detectors (except Final Exit zones) on the exit route.

 The Day LED will flash during the Exit Time.

 To cancel the setting procedure press the Ö (Escape) key.

 Once the system sets two confirmation beeps are emitted by the keypad and

internal speaker; after this the Ö (Escape) key does not function.

Easy Set  allows users to Set the system without entering their User Code. If Easy Set

is programmed you may set the system by pressing the # key, then the 1 (Full Set) key.

See SECTION 3: Programming the Accord; Group 4  Option 8 Easy Set.

Part Set [2]

To Part Set the system:

 Enter your User Code then press the 2 (Part Set) key.

 This starts the setting of the system using the Part Set zone programming.

This allows a sub-set of the system to be set.

 The Day LED will flash during the Exit Time.

 To cancel the setting procedure press the Ö (Escape) key.

 Once the system sets two confirmation beeps are emitted by the keypad and

internal speaker; after this the Ö (Escape) key does not function.

 The activation of the keypad buzzer and internal speaker are dependant on the

programming of Programming Group 4  Option 4 Part Set Exit Warning.

Easy Set  allows users to Part Set the system without entering their User Code. If

Easy Set is programmed you may set the system by pressing the # key, then the 2

(Part Set) key. See SECTION 3: Programming the Accord; Group 4  Option 8 Easy

Set

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

ADEMCO Accord Especificaciones Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Accord