ADEMCO VISTA 5140XM Guía para resolver problemas descargar pdf (Pagina 8)

- 8 -

Updated: 8/17/12

Tech Note

Total Load (ma @ 11.5) Vdc

22 ga

20 ga

18 ga

16 ga

1-16

6,000

17-24

4,850

6,000

25-32

3,640

5,850

6,000

33-40

2,910

4,680

6,000

41-48

2,420

3,900

6,000

49-56

2,080

3,350

5,290

6,000

57-64

1,820

2,930

4,630

6,000

65-72

1,620

2,600

4,110

6,000

73-80

1,450

2,340

3,700

5,880

81-88

1,320

2,130

3,370

5,350

89-96

1,210

1,950

3,090

4,900

197-104

1,120

1,800

2,850

4,520

105-112

1,040

1,670

2,650

4,200

113-120

970

1,560

2,470

3,920

121-128

910

1,460

2,310

3,680

Table 2: Polling Loop Wiring Using Shielded (or metal conduit) one side of the shield to ground.

Wiring Notes and Recomendations

• Twisted, stranded, non-shielded cable is recommended. Avoid sharp bends in the wire.

• Shielded cable, running Aux power in the same jacket, and/or running wire in metallic conduit increase the

capacitance of the wire run, which limits distances.

• Observe device and control requirements on serial number vs. dip-switch mode.

• Avoid running the cable near keypad wiring, intercom, or AC power lines, anything emitting RF noise.

• If the V/Plex device will go serial the device has to be programmed as serial.

• Shielded wire should have one end of the shield to good Earth Ground.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Tech Note 1

Comentarios a estos manuales

Sin comentarios

ADEMCO VISTA 5140XM Guía para resolver problemas Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VISTA 5140XM