ADEMCO Vista-10P Guía de usuario descargar pdf (Pagina 26)

– 26 –

Macro Key Program

Macro Key ProgramMacro Key Program

Macro Key Programming & Usage

ming & Usage ming & Usage

ming & Usage

(cont.)

(cont.)(cont.)

(cont.)

The keypad beeps to acknowledge your input and

displays the command you entered (followed by “F”).

3. Enter the next command, followed by press/holding

the “D” key for at least two seconds. The keypad

beeps and displays the keystrokes entered so far.

4. Repeat until all the desired commands (up to 16

characters including the “F”s) have been entered.

Be sure to check your keystrokes before continuing.

If you made a mistake, you must start over.

5. To exit, press/hold the “D” key for at least two

seconds. The display returns to system status and

indicates system is ready.

Typical Macro Alpha Display:

MACRO PGM

602F03F# 701F2F

Example of Macro Programming

Example of Macro ProgrammingExample of Macro Programming

Example of Macro Programming

Suppose you want to (1) bypass the two upstairs window zones, then (2) turn on an

exterior light, and then (3) arm the security system in the AWAY mode. The

procedures in the table that follows show you how you would program this macro:

Function

Keystrokes Required Keypad Display

1. Bypass zones 02 &

Press BYPASS [6] key, then

2-digit zone number 02, then

terminator “D”’ then [6], then 2-digit

zone number 03, then terminator “D”.

602F603

2. Insert terminator.

Press the “D” key for at least 2 seconds.

602F603F

3. Turn light on

(device 01).

Press [#] and 7 keys for “device ON”,

and [01] key for selecting device 1.

602F603F# 701F

4. Insert terminator.

Press the “D” key for at least 2 seconds.

602F603F# 701F

5. Arm system AWAY

Press AWAY [2] key.

602F603F# 701F2

6. Insert terminator.

Press the “D” key for at least 2 seconds.

602F603F# 701F2F

7. Exit Macro mode

Press the “D” key again.

Using a Programmed Macro Key

Using a Programmed Macro KeyUsing a Programmed Macro Key

Using a Programmed Macro Key

DISARMED

READY TO ARM

1. Press the Macro key programmed for the desired

series of commands for at least 2 seconds. The “Enter

User Code” prompt appears. The prompt remains

displayed for up to 30 seconds.

ENTER USER CODE

* * * *

2. Enter your 4-digit security code.

The programmed macro sequence begins

automatically after the user code is entered.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-10P Guía de usuario Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-10P