ADEMCO Accord Manual de usuario descargar pdf (Pagina 8)

NIGHT SET

Night Set permits the user to set the system in selected areas, whilst others are unset,

e.g. unset in bedrooms whilst set in remaining rooms of house. This permits

freedom of movement in the secure environment.

To NIGHT SET the system:

1. Enter the User Code.

2. Press 3/ (NIGHT SET).

During the exit period, the DAY LCD symbol  will flash. Two confirmation

beeps indicate that the system has set.

Note: To stop the system from setting during the exit period press Ö.

When the system has set, Ö will no longer function.

Press # + 3/ (Night Set) to EASY SET the system, if available.

Unsetting the System

To UNSET the system:

1. Proceed to a keypad via the approved route and enter the User Code.

Resetting the System

To UNSET and RESET the system during or after an alarm:

Entering a User Code will stop any alarm in progress. The zone number causing the

initial alarm will then be displayed on the LCD keypad. The User Code may be

entered again to RESET the system.

If the panel has been programmed to accept only an Engineer Reset after an alarm

an Engineer Code is required to RESET the system.

If the panel has been programmed to accept only a Technistore Reset the keypad

will flash the cE symbol followed by the activated zone number. The cE symbol

will then flash again followed by a five digit code which should be given to the

monitoring station who will then issue an anticode. This anticode will RESET the

system when entered on the keypad.

Testing the System

To TEST the system:

1. Enter the User Code.

2. Press 5/ (TEST).

The outside bell/sounder will ring for 5 seconds and the strobe will flash until the

test is finished. The keypad LCD scrolls through zone numbers 1-8 for 5 seconds.

Note: Test each zone individually when the keypad stops scrolling and the

bell/sounder stops ringing. Activate the zone to verify display of zone on

the LCD, two beeps will sound. To exit test mode enter the User Code and

wait for two beeps.

Omitting Zones

To OMIT Zones:

1. Enter the user code.

2. Press 6/ (OMIT).

3. Enter the Zone Number(s) to be omitted.

4. Press Ö to finish or wait 5 seconds for confirmation beep.

5. Set the system

e.g. To omit zones 6, 7 and 8, press 1234 6/ 678. Zone No. 6, 7 and 8 will

flash. Press Ö or wait 5 seconds for confirmation.

To correct a wrong omitted zone:

1. Enter the User Code

2. Press 6/ (Omit)

3. Press Ö or wait for a confirmation beep.

Note: Fire, Silent PA and PA cannot be omitted.

Unsetting the system, will restore normal operation and all zones.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

ADEMCO Accord Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Accord