INSTALLATION
The No. 5330 Alpha Console can be sutiace mounied or flush mounted. Refer
to the “Console Wifing” instructions in the Control/Communicator manual for
electrical requirements. Power to the Alpha Console is supplied by the
Control/Communicator.
1
2
3
4
SURFACE MOUNTING
Seled a Ioation for the console that is convenient for entering commands
and forreceiving thevatious visual andaudible system signals. Take the
Iocation’s fighting and Console height into consideration. Too bright an
area may make viewing with backlighting difficult, and the Console should
be mounted at a height that requires the User to look downward when
viewing the LCD &splay.
Run widng beWeen the Console and the Control/Communicator. Use a 4-
wire run as would normally be used with the specific system’s keypad
console, Terminate the wire run with the connector assembly provided
(Ademco No, SA5330-2) using the wiflng table that follows. Additional
Consoles may be mnnetied in parallel, with all consoles conneded at the
mntrol panel. DO NOT DAISY CHAIN CONSOLES! Forrunsof less than
100 feet, #22conductors maybe used. Forlonger runs, thewire size to
be used depends upn the distance required. Usethefollowing table to
determine the correct wire size.
mw
WIRE S17F
Up to 100(30m)
#22(0.65 mmO.D.)
100 to 200’(60m)
#20(0.8 mmO.D,)
200 to 30V(90m) #18(1 mmO.D.)
The following chati should be used when witing the No. 5330
5330 ALERT VECTOR 4180
4160 4130XM
VISTA
(mlor) Ts TB1 TB2 TB
5130XM
4140XM
Red 19
14 20 20
redblack TB2-7
Yellow 4 15 19 17
Yellow
TB1-9
Green 6 18 18
15 Green
TB1-t O
Bla& 18
t7
16
16 Bla*
TB2-6
Remove the mounting plate from Ihe back of the Console by insefling a
small =rewdfiver blade ucder the Iockng tab (located in the center of the
backofthe tinsole, between the Console andthe piate), twisting gently,
andsliding the Console upward. Using themounting template (N3325),
drill the four mounting %rew holes, and the mnnector access hole. Route
thewifing in the wall through the access hole and mount the Console
mounting plate in place.
Place the U-shaped wire jumper, located in the receptacle opening, to the
proper ~sition for the system in use:
6V =5620/5720, 4160-12, 4180 EC/4180-12
12V =5800, Vxtor2000, Vetior3000, and Wsta
IMPORTANT! Failure to position jumper properly when us;ng 6V
operation will result in the Console appearing to be faulty andinoperat;ve.
The system defauhs to 12Vm&e ifjumper is not used.
2
(24 paginas)
(173 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales