
FEDERAL COMMUNICATIONS COMMISSION
(FCC) STATEMENT
This equipment has been tested to FCC requirements and has been found
acceptable for use, The FCC requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and
used properly, that is, in sttict accordance with the manufacturer’s instructions, may
=use intederence to radio and television reception. It has been type !ested and
found to wmply with the limits for a Class B computing device in accordance with
the specifications in Subpafl J of Pati 15 of FCC Rules, which are designed to
provide reasonable protetiion against such intetierence in a residential installation.
However, there is no guarantee that intederence will not occur in a pa flicular
installation. If this equipment does cause intetierence to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the intederence by one or more of the following
measuras:
. If using an indoor antenna, have a quafity outdoor antenna installed.
. Reotient the receiving antenna until infetierence is reduced or eliminated.
. Move the receiver away from the controllcommunicator.
. Move the antenna leads away from any wire runs to the controllcommunicator.
. Plug the controltcommunicator into a different outlet so that it and the receiver
are on different branch circuits.
H ne=ssa~, the user should consult the dealer or an experienced radioltelevision
technician for additional suggestions.
The user or installer may find the following booklet prepared by the Federal
Communications Commission helpful:
‘,lntetierence HandbooW
This koklet is available from tha U.S. Government Printing Office, Washington, DC
20402. Stock No. 004-000-00450-7.
The user shall not make any changes or modifications to the equipment unless
authorized by tha Installation Instrutiions or User’s Manual. Unauthorized changes
or modifications could void the user’s authotity to operate the equipment.
IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS
In the avent of telephone operational problems, disconnect the Control by
removing the plug from tha RJ31X wall jack. We recommend that you
demonstrate disconnecting thephones oninstallation of the system. Do not
disconnect thaphone connetiion inside the Control Doing sowillresult in the
Iossofyour phona lines. lftheregular phone works correctly after the Control
has baen disconnected from the phone lines, The Controlhas a problem and
should bereturned for repair. lfupondisconnection of the Control there is still
a problem on the line, notify thetelephone company that they have a problem
andrequest prompt repair sewice. Theuser may not under any circumstances
tinOrOut Ofwarranty) anemptany sewiceor repairs tothe system. It must be
returned lothefatioV or an a“thotized sewice age”cy for all repairs.
18
Comentarios a estos manuales