ADEMCO 4160-12 C-COM Especificaciones descargar pdf (Pagina 48)

15. tperore the Test @bde jmper to restore the system to normal functioning.

16. Disconnect AC power

to the system.

The POWER LEO on the console

and on the C-COM

should

go out within 5 seconds, but the system should

remain operable.

After an installer PROM programned AC Loss delay

(up to 36 minutes), a rapidly pulsing trouble sound will be produced

at consoles and keypads and an AC Loss report will be communicated

tx8 the central station.

Keying of the security code and OFF or turning

of the arm/disarm key is required to silence the trouble sounding.

JOlJ:

The AC Loss sounding is suppressed while the system is

armed. The sound is only produced when the OFF LED (on

the console) is lit.

Restore AC power to the system.

17.

Am the system and strul

ate leavlrg the presi

ses by following the

procedures in the OPERATION Section.

18.

SImulatc by entering the premfses and

dlsam the system by following

the procedure given in the OPERATION Section.

VII. WERATIOR

AC POUER LED OR TtE C-C(u ARD EACH SECURITY CORSOlE SHWLP BE LIT AT AU

TIMES.

If out, AC failure

indicated and the system is operating on battery. Check

plug-in transformer or for power failure.

To kr hglary system

H&e sure

the

K PWER LED is lit.

The READY LED on the console, remote keypad, or remote

key

arming station

shuuld be llt to indicate that all zones are properly closed.

If the

READY LED is

not lit,. check the Zone I.D. Display on the console

(depress READY key to get display) or the zone LEDs on the C-COM. A faulted

zone

indication denotes a fault which must be cleared or the zone shunted

(prior to arming by individual zone shunt or during arming by the special

automatic shunting forced arming sequence, in order to arm the system).

Hake sure that the exit door is closed!

Enter the security code at the consale or rmoe keypad or turn the am/

dtsam hey.

remalnlng on the premises after

rmirg, immediately (within 2

seconds of code entry) press the STAY key.

Interior zone 3 should

now be turned OFF and the. rest of burglary zones in the system should

now be armed (entry/exit zones after exit delay timeout). This is

indicated at consoles and keypads by 3 brief tones and the lighting

of the STAY LED.

leavhg the premhes after arm/jointfilesconvert/310207/bg,

immediately (within 2 seconds

of code entry) press the AWAY key.

All burglary zones should now

be armed (entry/exit zones after exit delay timeout). This is indicated

at consoles and keypads.

2 brief tones and the lighting of the

AWAY LED.

628-48

725

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 58 59

Comentarios a estos manuales

Sin comentarios

ADEMCO 4160-12 C-COM Especificaciones Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4160-12 C-COM