ADEMCO 4160-12 C-COM Especificaciones descargar pdf (Pagina 37)

or not).

In addition, the system is placed in a test mode

(if the system is disarmed and no memory of alarm is present)

in which activation of

any

zone causes a brief l/2 second

sounding from the exterior alarm sounder(s), as.we1.l as

visual zone annunciation on the console's zone identification

display and on the appropriate C-COM zone LED (all but

zone 5). If the lest Mode is not manually terminated,

the system will automatically come out of the Test Mode

after 30 minutes.

tlot

IJssd

Am/Disam Input

(Momentary'HI to ARM or DISARM): This

input is normally provided by remote key arming stations

(e.g. t&s. 9787, 9789) for the purpose of arming or disarming

the system.

If the zone status indicates an open zone

and arming is desired in spite of the open zone, maintaining

this input HI for 5 seconds causes forced arming of the

system (automatic shunting of the open zone).

Once the system is disarmed, the silencing of any remaining

trouble or alan memory sound is accomplished by reactivating

this HI input. As long as conditions remain that need

to be cleared, activation of a key arming station cannot

rearm the system, only reset the interior audible annuncia-

tions.

Up to four arming stations can be supported by

the system.

lB2

Tcralnal s

1.3

4,5

6,7 ZONE

7,8 ZOM 2

9,lO ZOM 3

Incming Teko

Line Pair:

Connect T82-1 to the GREEN lead and TB2-3 to the RED lead on

the No. 620 RJ31X Direct Connect Cord. Do su& camat the latter

cord

to the

RJ31X

jack

until all wiring in the system has been

completed.

Cabinet Gromd (-):

Connect this terminal to a, good earth ground

(cold water pipe or electrical box ground is frequently satisfactory

for this usage,

but in some local

es is

not).

This connection

Is critlcal

to enhancing the immunity of the system to unwanted

induced voltages.

Internal Handsets:

Connect TB2-4 to the BROGlN lead and TB2-5

to the GRAY lead on the (JD. 620 RJ31X Direct Connect Cord.

Burg1 ary Protecti 8n Zones :

For each zone, run a pair of wires

from that zone's terminals to all protection points in the zone

and .terminate with a

1000

ohm End-of-Line Resistor (supplied)..

Each loop has normal (250 msec)

response

to open and closed

circuit devices such as mats, magnetic contacts, foil, etc.

Zones 2 and 3 are PROM progranmnable for

fast response (15

msec)

to quick acting devices such as vibration contacts and photoelectric

units without built-in delay.

628-37

714

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 58 59

Comentarios a estos manuales

Sin comentarios

ADEMCO 4160-12 C-COM Especificaciones Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4160-12 C-COM