ADEMCO 4160-12 C-COM Especificaciones descargar pdf (Pagina 50)

Connect the positive (+) phone wire to the ‘+/T” teminal and the

negative (-) phone tire to the “-/R” ter~nd.

When all the phone lines have been connected, they may he tested at

anY time bY m~entarily pressing the SYSTEM TEST button on the

No. 685’s front panel.

Within 10 seconds, all of the phone lines will

be tested. If SOY of the lines shows a f~lme, check the polarity of

the tiri~.

fiso check to tie sme that the phone ltie has been

connected to the line card tia the 3 pin connector located at the top

of the ltie -d.

~ aut-tic test of the telephone lines till be made by the NO. 685,

if no calls are received for 10 minutes. The test occurs as follows:

1) The Dhone line is seized for 2 seconds.

2) A check is made for loop current in the line. If no current is

found, a phone line failure will be flagged and a message will be

generated.

The line is returned to the “On hookn condition.

Regular maintenance and

frequent testing by the

~y alarm systm.

TO TSR ~STALLSR

inspection (at least annuslly) by the installer and

user are vital to continuous satisfactory operation of

The installer shotid assume the responsibility of developing and offering

regular

maintenance prosram to the user as well as acquainting the user with the

proper operation and limitations of the alarm system and its component parts.

Recommendations must be included for a specific program of frequent testing (at

least weekly) to iname the system!s proper o~ration at all times.

AC POWSR LIGHT OFF

AC ~wer loss. Operating on battery.

. SYSTEM OPERAT~G

Fuse Blmn (3A SLO-BLO, e g., No. ~-10).

AC POWSR LIGHT OFF A. AC rower 10SS. ~ttery

. SYSTEM NOT OPERATING Dead or Disconnected.

B. Check fuses.

. AC POWER LIGHT ON A. Depress SYSTRM RESET swit~.

SYSTSM NOT OPERATING

Remove power (AC and battery)

(NOT ANSWR~NG ALAR~)

and reset all cards.

LHE FAULT DISPLAYED A.

Check phone

line connections.

FOR L~ES #1 B. Check phone line voltaga and Wlsrity (see

THROUGH 8. Section VIII B).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4160-12 C-COM Especificaciones Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4160-12 C-COM