ADEMCO 4160-12 C-COM Especificaciones descargar pdf (Pagina 23)

Conditions which produce an En~ish language output are anything other

than a previously reported event or a nom~ event; however, when

multiple conditions occur on one transmission, the printer will

produce an (M) in front of the m~sage.

Using the same identification

numbers as the previous e~ples and assming that channels 1 and 3

are activated at 6:3o PM on March 15,

and assuming the English

language output for channel

1 is HOLD-UP ALARN ad the E@ish

language output for chanel 3 is BURGLAR ALARM, the following message

will appear on the printer:

6:30 PM 3/15 13 8531 1515 5555 7 (M) HOLD-UP ALARM

If a transmission received a kissoff from the No. 685 it is designated

as a verified message and identified with the letter (V) as shown

below:

6:3o PM 3/15 13 8531 1555 5555 7 (V) HOLD-UP ALARM

If a transmission contains multiple alarms ad is verifiedp

it is identified by the letters (M) ad (V), as shown belw:

6:30 PM 3/15 13 8531 1515 5555 7 (M) (V) HOLD-UP ALARM

If the No. 685 is switched to the PRINT VALID position, all

messages other than fatit m-sages w~l contain a (V).

The No. 685

is =pable of receiving espanded low s~ed reports and Checksm

Verified* messages in either the NON-E~ ANDED or En ANDED repcrting modes

[ERANDED mode identifies opening and closing by war ~ trouble and restore

by mne (channel) and an dso reprt lcw bttery restore].

●

De@ding of messages with a parity check must k PROM enabled because

the receiver needs a way of distinguishing 3-di@t subscriber ID/l-

digit event with checksum messages frm 4-digit subscrikr ID/1-@git

event messages since they are the sme length (see Section VI C).

When a message is received in the UOU-E~AWDED reporting mh, the

input and output messages will be simflar to LOW SPEED fomat m~sagea

(see Section IV A) but will use Radionics alarm codes,~ indi~ted

in Table C.

In the E~A~KD reporti~ mode,

opning, clming, trouble and restore

reports are transmitted using pairs of massages.

The first message @ves

the accomt nmber md the type of event (the Radionics alarm mde for

OPEN~G is W“, CL~~G is ‘Cn

, RHTORE is qn ad TROUBLE (=d SHUNT) is

~n).

me second m~sage will have an ‘acmmt numbarn of BBB, CCC, EEE’or

FFF (OPENmG, CL~~G, R=TO~ or TROUBLE) and the “alarm codefi will

indi=t e the affected channel or user.

For essmple, if a RESTORE occurs on

ch-el 1 at the premises of account 890, the following sequence wofid be

received (assumed RECENER No. 1, Group No. 3):

13 0890 E

13 OEEE 1

(Cent’d on page 25)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4160-12 C-COM Especificaciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4160-12 C-COM