ADEMCO 4160-12 C-COM Especificaciones descargar pdf (Pagina 16)

LOW SPSSN (Ademeo Stan*d, Raditics, SsdioniS Supsrf=t or S=~A)

Fmat:

Dis@ay, M SP= F-at:

When a si~d is received via a Line Card

imt~led in the No. 685, the si~d will be displayed as six identi-

fication &@ts followed by a singe di@t am code.

A typical

display mi~t be:

12 0865 2 (pi= T~ snd DATE)

The first digit (1) represents the receiver number setting of

the RECRNER NWER switch on tk No. 685 (see Section III Cl).

The second digit (2) represents the group or rotary nmsbsr (1-8) which

the usr has sasi~ed to the tele~one line processing the =11. Up

to 8 rotary identifiers may be assigned. Conversely, al 8 ptine lin~

may be assigned the ssme rotary nmbsr.

This number is ~ogr~ed

during the Line Card Setup Procedure (sse Section VII A).

The third throu@ sifih digits (0865) repr~at the subscribers

account nmebsr.

The No. 685 Receiver is desi~ed to accept > or k

di@t aocount nmbsrs se supplied by LOW SPEED Adsm@, Radionics or

S=COA c=ticato=. When reoei~ng 3-digit LOW SP~ si~ds, the

receiver adds a O ahead of the 34~t acwmt nmber as shown in this

e=ple.

The fi- di@t (2) represents the transmitted alsrm code, which can

be any code fra O through 9 or B though F.

With the No. 685 in the A~OWATIC mode, the characters on the display

wfll ap~sr as they are received and processed by the No. 685.

If the

semnd transmission is identical to the first, the display will not

~angs (except for the VALID LED, which will light for the second

message). ~tid the transmission change , the nsw~y transmitted

sign~ wfll appear on the display screm. In the ~UAL mode, the

previous message will remain on the ~splay until the DISPMY NE~

~SAGE button is depressed.

If mtitiple traosmissione are received frm a commuoicstor,they will

nom~ly al be hsn~ed by the No. 685 on the same odl. M~sagss are

displayed on the No. 685 in succession as if they were se~rate

messages frm clifferent cmmcat O=.

Mot*,

W SP- Fe:

When a printer is used with the No. 685,

it mn be operated in one of two modes:

PRINT ALL or PRINT V&ID

ONLY. ti the P~NT ALL mode, every m-sage recsimd by the No. 685

wfll be printed.

In tk PRINT VAL~ ofiy successf~ transmis~om

whioh have been Hssed-of f will te printed. ~S means, under norm~

conditions, for ewry tw messages reoeiwd ofiy one will be printed,

in an <fort to cn~srvs ~psr and minimize operator re~sw time. _

However, when tid or Pr transmissions are received, an error mssags

wfll be printed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comentarios a estos manuales

Sin comentarios

ADEMCO 4160-12 C-COM Especificaciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO 4160-12 C-COM