ADEMCO 4140XMPT2 Manual de instalación descargar pdf (Pagina 46)

LJL NOTICE: This is a “GRADE A“ svstem.

“FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT”

rhis equipment has been tested to FCC requirements and has been found a~ceptable for use. The FCC requires the following I

itatemint for your information:

rhis

equipmentgeneratesandUsesradiofrequency energy and if not installed and used properly, that is, in strict accordance with ‘~

manufacturer’s instructions, may cause interference to radio and television reception. It has been type tested and found to comply with

he limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide

easonabie protection against such interference

in a residential installation. However, there is no guarantee that interference will not

ccur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by

urning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

● If using an indoor antenna, have a quality outdoor antenna installed.

● Reorient the receiving antenna until interference is reduced or eliminated.

● Move the receiver away from the control/communicator.

● Move the antenna leads away from any wire runs to the amtrol/communicator.

s Plug the rmntrolkommunicator into a different outlet so that it and

the receiver are on different branch circuits.

f necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.

‘he user or installer may find the following booklet prepared by the Federal Communications Commission helpful: “Interference

{andbook”

‘his booklet is available from the U.S. Government Printing Office, Washington, DC 20402.

“he user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User’s

flanual. Unauthorized changes or modifications could void the user’s authority to operate the equipment.

IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS

In the event of telephone operational problems, disconnect the control by removing the plug from the RJ31 X wall jack. We recommend

that your certified installer demonstrate disconnecting the phones on installation of the system. Do not disconnect the phone

connection inside the controlkommunicator. Doing so will result in the loss of your phone lines. If the regular phone works correctly

after the control/communicator has been disconnected from the phone lines, the controlkommunicator has a problem and should be

returned for repair. If upon disconnection of the controkcrmmunicator, there is still a problem on the line, notify the telephone company

that they have a problem and request prompt repair service. The user may not under any circumstances (in or out of warranty) attempt

any service or repairs to the system. It must be returned to the factory or an authorized service agency for all repairs.

-46-

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Sin comentarios

ADEMCO 4140XMPT2 Manual de instalación Pagina 46