ADEMCO 4140XMPT2 Manual de instalación descargar pdf (Pagina 32)

TESTING THE SYSTEM

Testing Your System 1.

Open and close each protected door and window in turn and listen for three

beeps. The identification of each faulted protection point should appear on the ~

display.

2. Walk in front of any interior motion detectors (if used) and listen for three beeps

as movement is detected. The identification of the detector should appear on the

display when it is activated.

3. Follow the manufacturer’s instructionsto test all smoke detectors to ensure that all

are functioning properly. The identification of each detector (or the zone number

of the zone assigned to the detector) should appear on the display when each

is activated.

4. When all protection points have bee,n checked, there should be no zone

identification numbers displayed. If a problem is experienced with any protection

point (no confirming sounds, no display), CALL FOR SERVICE IMMEDIATELY.

5. Turn off Test mode by entering the security code and pressing the OFF key.

-32-

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 53 54

Sin comentarios

ADEMCO 4140XMPT2 Manual de instalación Pagina 32