ADEMCO Security System VISTA-15CN Manual de usuario descargar pdf (Pagina 11)

– 11 –

SPECIAL MESSAGES

OC =

OPEN CIRCUIT (no communication between console and control).

ENTRY ERROR

= ERROR (invalid field number entered; re-enter valid field number).

After powering up, "

AC, dI

(disabled) or "

Busy Standby

" and "

NOT READY

" will be displayed after approximately 4 seconds.

This will revert to

READY

in approximately. 1 minute, which allows PIRS, etc. to stabilize.

To bypass this delay, press: # + 0.

appears, more zones than the expansion units can handle have been programmed. Correct the programming and

then completely de-power and re-power the control to clear this indication and remove the disable indication.

TO ENTER PROGRAMMING MODE:

POWER UP, then press

✱

and

both at once, within 50 seconds of powering up.

Initially, key:

Installer Code

(

4 + 1 + 1 + 2)

plus

8 + 0 + 0.

If different

Installer Code

is programmed, key:

New Installer Code + 8 + 0 + 0.

(If

✱

98 was used to exit previously, method 1 above must be used to enter the program mode again.)

TO EXIT PROGRAMMING MODE:

✱

Exits programming mode and

prevents

re-entry by keying Installer Code + 8 + 0 + 0. If

✱

is used to exit

programming mode, system must be powered down, and method 1 above used to enter the programming mode.

✱

Exits programming mode and

allows

re-entry by keying Installer Code + 8 + 0 + 0; or by powering up, then pressing

✱

and # within 50 seconds of power-up.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

ADEMCO Security System VISTA-15CN Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Security System VISTA-15CN