ADEMCO LYNXR-EN Guia de preparacion Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
- 8 -
Field Function
Programmed Values[ ] = Table 1 Default Value
75
RF XMTR LO BAT RST RPT CODE
|
[1,0]
76
TEST RESTORE RPT CODE
|
[0,0]
OUTPUT AND SYSTEM SETUP (
*
80–
*
92)
80
81
DEVICE PROGRAMMING MENU
MODE
ZONE LISTS MENU MODE
Program *80 and *81 only if Powerline Carrier Devices or chime
by zone are to be used. See procedure later in this manual.
83
ENHANCED SEQUENTIAL MODE See procedure later in this manual.
84
ASSIGN ZONE VOICE
DESCRIPTOR
See procedure later in this manual.
85
RECORD CUSTOM VOICE
DESCRIPTOR
See procedure later in this manual.
87
AUX FUNCTION/ 1-BUTTON
PAGING
[0]
0 = Aux key performs defined function (macro);
1 = Aux key sends message to pager or voice message to follow me
system phone number.
If 1, you must also select an option 6-9 in field *49 for the pager or 10-
13 for the follow me system announcement.
88
PAGER CHARACTERS
Up to 16 digits can be entered that will appear in front of the 7-digit
pager message sent by the control (either upon system event or upon
pressing AUX key [if programmed for paging]; see field *87 and *49 for
other options regarding the paging feature). See the Installation
Instructions (fields *87, *88 and *49) for full descriptions of the paging
feature. You do not need to fill all 16 digits (press [*] to advance to
next field). To clear entries, enter *88*.
To enter “*” = [#] + [11]; To enter “#” = [#] + 12]
To enter 2-second pause = [#] + [13] (some pagers require an
additional delay [pause] in order to receive the entire message)
89
EVENT LOG 80% FULL RPT CODE
|
[0,0]
90
EVENT LOGGING
[15]
0 = None; 1 = Alarm/Alarm Restore; 2 = Trouble/Trouble Restore;
4 = Bypass/Bypass Restore; 8 = Open/Close.
Example:
To select “Alarm/Alarm Restore”, and “Open/Close”, enter 9
(1 + 8); To select all, enter #15.
Note:
System messages are logged when any non-zero selection is made.
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comentarios a estos manuales

Sin comentarios