ADEMCO 4110XM Manual de usuario descargar pdf (Pagina 5)

–5–

(continued) SYSTEM OVERVIEW

Alarms

When an alarm occurs, both the keypad and external sounders will sound,

and a message at the keypad will identify the zone(s) causing the alarm. In

addition, if your system is connected to a central monitoring station, an

alarm message will be sent. To stop the alarm sounding, you simply disarm

the system.

Fire Protection

The fire protection portion of your security system (if used) is always on

and will sound an alarm if a fire condition is detected. Refer to the

FIRE

ALARM SYSTEM

section for important information concerning fire pro-

tection, smoke detectors and planning emergency exit routes from your

premises.

Burglary Protection

The burglary protection portion of your system must be turned on or

"armed" before it will sense burglary alarm conditions and sound an alarm.

Your system can be armed in one of four modes: STAY, AWAY, INSTANT

and MAXIMUM. Refer to the

ARMING THE SYSTEM

sections for

instructions in using these modes of operation.

Your system also provides a CHIME mode for alerting you to the opening

and closing of doors and windows while the system is disarmed.

Memory Of Alarm

When an alarm or trouble condition occurs, the keypad displays the

number(s) of the zone(s) that caused the problem, and displays the type

of alarm or trouble (ex. FIRE, ALARM, CHECK). The display remains until it

is cleared by entering the OFF sequence (security code + OFF key) twice.

Pager Notification

If you have chosen to be notified of alarms or other system conditions by

pager, the following codes will be sent to your pager by the control:

1811=Trouble 1911=Alarm

1001=Open 1002=Close

1 2 3 4 5 6 7 8 9 10 ... 43 44

Sin comentarios

ADEMCO 4110XM Manual de usuario Pagina 5