ADEMCO Vista-20HW Guía para resolver problemas descargar pdf (Pagina 28)

100

Programming

Wined Expansion Zones

1. With at least one 2-line Alpha keypad (5137AD or 6139) connected to the

Partition 1 keypad terminals on the control, power up the system

temporarily. If you had previously connected the AC transformer to the

control panel, you need only plug in the transformer (to 120VAC outlet) to

power up the system.

2. Enter the programming mode by keying the following on the Alpha

keypad: Installer code (41 12) + 8 + O+ O.

3. Press *56. Note that this k an interactive programming mode. It is used

to program zone numbers, zone types, partition numbers, and alsrm

report codes for all zones that are going to be used.

-LZoneNumber

Ezziil

II 10 Partition

Enter the first zone number that you wish to

program (or [01[01to exit zone programming).

Normally, you will be starting with zone 10, so

enter “1O”. Press [*] to continue.

A summary display will appear, showing the

present status of that zone’s programming.

Zn = zone numbe~

ZT = zone @pw

P = partition to which zone is assigned;

RC = report code for that zone;

In= input type of zone (AW for Aux Wired).

L = Loop (not used for wired expansion zones)

Values in the summary display are the

currently programmed values.

To start programming zone 10, press [*]. A

prompt for Zone Type will appear.

Each zone must be assigned a zone type, which

defines the way in which the system responds to

faults in that zone. A detailed explanation of

each zone type is provided in “Response ~pe

Definitions” in Section 16. ZONE RESPONSE

TYPE DEFINITIONS.

Enter the desired zone type,as listed below.

00= ZoneNotUsed

07= 24 Hr Audible

01= Entry/Exit#1

08=24 HrAux

02= Entrv/Exit#2

09= Fire

03= PeAeter

10= Interiorwillelay

04= InteriorFollower

23= No Alarm

05= TroubleDay/AlarmNight

Response

06= 24Hr Silent

24= SilentBurglary

When the display shows the zone type you want,

press [*] to continue.

Enter the partition to which a zone is to be

assigned.

Enter “l” or “2”. The default is

partition 1.

Press [*] to continue.

-26-

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 99 100

Comentarios a estos manuales

Sin comentarios

ADEMCO Vista-20HW Guía para resolver problemas Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO Vista-20HW