ADEMCO VIA 30+ Manual de usuario descargar pdf (Pagina 6)

–6–

OUTPUT RELAYS WORKSHEET FOR FIELDS *80, and *81.

Applicable only if relays are to be used.

Fill in required data and follow detailed programming procedure

described in PROGRAMMING DATA FIELDS section of Installation Instructions

*80 OUTPUT RELAYS

Notes:

1. Field *25 must be programmed for a 4229 (Relays 01 and 02) or a 4204 (Relays 01 to 04).

2. Tampers of contacts or expansion units cannot be used to operate relays.

S T A R T

←either or both→

S T O P

←either or both→

OUTPUT

RELAY

ACTION

(A)

ZONE

EVENT LIST

(EV) (ZL)

ZONE TYPE

/SYST OP'N

(ZT)

"RESTORE of"

ZONE LIST

(ZL)

ZONE TYPE

/SYST OP'N

(ZT)

Where: A = RELAY ACTION 0 = No Response; 1 = Close for 2 sec; 2 = Close and stay closed; 3 = Pulse on and off

EV = EVENT 0 = Not used; 1 = Alarm; 2 = Fault; 3 = Trouble

ZL = ZONE LIST 1,2, or 3 (from Field *81) or 0 = Not Used.

START ZONE LIST : Upon alarm, fault, or trouble of ANY zone on this list, relay action will START.

STOP

"RESTORE

of"

ZONE LIST: Upon restore of ALL zones on this list, relay action will STOP.

It need not be same list as used for START.

ZT = ZONE TYPE/SYSTEM OPERATION

Choices for Zone Types are:

00 = Not Used 06 = 24 Hr Silent

01 = Entry/Exit 07 = 24 Hr Audible

03 = Perimeter 08 = 24 Hr Aux

04 = Interior Follower 09 = Fire Trouble

05 = Trouble Day/Alarm Night 10 = Interior w/Delay

Note:

Any

zone in "ZT" going into alarm,

fault, or trouble will actuate relay.

Any

zone of that type that restores

will stop relay action.

Choices for System Operation are:

20 = Arming–Stay 33 = Any Burglary Alarm 39 = Any Fire Alarm

21 = Arming–Away 34 = Code + # + 7 Key Entry 40 = Bypassing

22 = Disarming (Code + OFF) 35 = Code + # + 8 Key Entry 41 = AC Power Failure

31 = End of Exit Time 36 = At Bell Timeout** 42 = System Battery Low

32 = Start of Entry Time 38 = Chime 58 = Duress

**Or at Disarming, whichever occurs earlier.

*81 ZONE LISTS FOR OUTPUT RELAYS Record desired zone numbers. More or fewer boxes than shown may be

needed, since any list may include

any

all

of system's zone numbers.

Zone List 1: Started or stopped by zone numbers (enter 00 to end entries).

, , , , , , , , , ...etc.

Zone List 2: Started or stopped by zone numbers (enter 00 to end entries).

, , , , , , , , , ...etc.

Zone List 3: Started or stopped by zone numbers (enter 00 to end entries).

, , , , , , , , , ...etc.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comentarios a estos manuales

Sin comentarios

ADEMCO VIA 30+ Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad ADEMCO VIA 30+